5 Cut Method Calculator

Label the fifth strip before moving it
A = end farthest from you. B = end nearest you and the working fence. Left/right are viewed from the operator position.

Optional accuracy check

Compare the estimated error over your chosen cut length. Width uncertainty is a ± bound for each A/B reading; 0 means uncertainty is not evaluated.

Formula & measurement notes

Signed correction = (A − B) × D ÷ (4 × L). L is the distance between the two width measurement positions. D is the distance from the fixed pivot to the actual adjustment point.

Use the working fence nearest you. Keep the same panel face up, rotate in the indicated direction, and seat each freshly cut edge against the fence. Decimal readings are best for A and B; fractions such as 12 1/2 are also accepted.

Method reference: Katz-Moses five-cut guide .

What Is A 5 Cut Method Calculator?

The 5 cut method calculator allows you to square a table saw crosscut sled fence. It uses the width measurement on both sides of your fifth-cut strip, your strip length, and the distance from your fence pivot to your adjustment point.

This tool estimates how much and in what direction you should adjust your fence. It can convert between inches and millimeters and checks the cutting error estimate against the specified tolerance.

Short FAQs

1. Why do you need to divide the 5-cut formula by four?

Because each cut multiplies the fence error four times. Divide your measured taper value by four to estimate the error per one cut.

2. How do you determine the A and B ends?

When using this calculator, you have to input the end A of your strip that is the furthest from you after the fifth cut. The other one is end B.

3. What is the pivot distance?

Pivot distance is the distance between the fixed pivot screw and the place where you will move your fence.